Entries by

Microcontroller (Interface) Firmware 1.9.1.4x

March 18, 2019 in , /by

  Model Microcontroller (Interface) Upgrade Command Syrus 3 Bluetooth (S3GBT-2481) >SIV1.9.1.4T< Syrus 3G+ (S3G-2480) >SIV1.9.1.4T< Syrus 3GLC (SL3G-1645) >SIV1.9.1.4C< Syrus 3 US/EU (SY-2340) >SIV1.9.1.4F< Syrus CloudConnect (SL-1445) >SIV1.9.1.4L< Syrus CloudConnect Plus (SL-1645) >SIV1.9.1.4W< Added 3 new thresholds were added for the Aggressive Curve detection algorithm. New thresholds are S6(100 milli-g), S7(150 milli-g) and S5(200 milli-g)….

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

ECU Monitor Firmware 5.0.12

March 18, 2019 in , /by

Upgrade Command: >SXAEM1ecu_5.0.12< Fixed Fixed, erroneous values on the FAN Status and ABS Status parameters for J1939 protocol Please note that this upgrade can take between 8-10 minutes, so it’s recommended to do the upgrade when the vehicle’s ignition is OFF, and the ECU is powered permanently. An ignition transition would not cause loss but it…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

Integrating 3rd Party Accessories

December 7, 2018 in /by

The following guide will show you how to add custom data to Pegasus from any sensor that’s capable of sending bytes of information via RS-232. At the end of the guide you’ll be able to receive the information via rawdata and have it forwarded to any endpoint. Download…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

ECU Monitor Firmware 5.0.11

August 20, 2018 in , /by

Upgrade Command: >SXAEM1ecu_5.0.11< Added Added, Support for the ContiPressureCheck TPMS accessory from Continental Added, Support for the J1939 500kHz CAN networks Please note that this upgrade can take between 13-15 minutes, so it’s recommended to do the upgrade when the vehicle’s ignition is OFF, and the ECU is powered permanently. An ignition transition would not…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

Syrus 3 & CloudConnect Firmwares 3.3.84

August 20, 2018 in , /by

Upgrade Command Upgrade all command (FW, Interface & Bluetooth) Corrections Fixed, a reference time on i2c thread was causing bluetooth upgrade to fail. Fixed, the mechanism to auto start an upgrade when syrus interface is in boot mode. Fixed, a reference time on i2c thread was causing Input/Output expander to fail. Fixed, MDT serial port…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here