Entries by

Syrus 3 & CloudConnect Firmwares 3.3.77

July 18, 2018 in , /by

Upgrade Command >SXAFUGW< Important – Firmware 3.3.77 replaces firmwares 3.3.59 & 3.3.71, it is important that your devices are upgraded to this stable version, the changes between this release note and the previous one are detailed below in italics. After upgrading the Syrus firmware make sure to upgrade the microcontroller’s (interface) FW – see the…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

ECU Monitor Firmware 4.2.0

August 24, 2016 in /by

Upgrade Command: >SXAEM1ecu_4.2.0< Improvements [list icon=”carat-1-e”] [item]Improvement, analog sensor signal for fuel level differential[/item] [item]Improvement, overall in communication with the Engine parameters read[/item] [/list] Additions [list icon=”carat-1-e”] [item]Added, dual protocol support with J1708 & J1939 parameters read simultaneously[/item] [item]Added, dual protocol support with J1708 & Mobileye parameters read simultaneously[/item] [item]Added, new protocol for Mobileye accessory[/item]…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

Syrus 2 Firmware 2.3.8

May 6, 2016 in /by

Upgrade Command: >SXAFU0C< Corrections [list icon=”carat-1-e”] [item]Fixed, Mobileye detection flag was not being set [/item] [item]Fixed, communication timeouts between Syrus and Garmin (error 82) [/item] [item]Fixed, GPS back log (XAKL) was returning the coordinates with wrong values, the latitude and longitude sign was changing [/item] [item]Fixed, Baudrate (XABR) command was being executed when an event was defined…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

Syrus 2 Firmware 2.2.3

December 18, 2015 in /by

Corrections [list icon=”carat-1-e”] [item]Fixed, sometimes the pulse counter value was incremented by one during a system reset  [/item] [item]Fixed, sometimes the GPS module jumps to the future. If this condition is detected a full cold start is executed [/item] [item]Fixed, sometimes the gps speed reported in EV frames while in MDT mode were inconsistent and reported…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

Pegasus Gateway Guide

April 17, 2015 in , /by

Pegasus Gateway Guide Is avaiable now, the first Pegasus Gateway Guide – Inside, you will find relevant information and functionality of the Pegasus Gateway which has been developed to fully integrate our Syrus line of products.  Pegasus Gateway Guide – v1.4     Questions: support@digitalcomtech.com  …

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

ECU Monitor Firmware 3.3

March 10, 2015 in /by

ECU Monitor FW 4.1.3 Release Notes! Corrections [list icon=”carat-1-e”] [item]Bug corrected from prior version  2.9 that was causing issues with the “Seatbelt state” reading[/item] [item]Bug corrected from prior version 2.9 that was causing “Total Vehicle Gross Weight” parameter to not be read properly[/item] [item]Bug corrected that was causing J1939 axles’ weights to report wrong values[/item]…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here

Syrus 2 Firmware 2.1.48

February 3, 2015 in /by

Corrections [list icon=”carat-1-e”] [item]Fixed, a Pulse Counter threshold that was not defined was triggering Pulse Counter signals Pxx[/item] [item]Fixed, ECU weights parameters were updated with wrong values. Values greater than 0xFB00 means that the weight value is not available.[/item] [/list] Changes [list icon=”carat-1-e”] [item]Changed, the time that the application can remain on Airplane mode from…

This content is for registered Members only. You can register for free!
Login to view this content, or Register here