New Search

If you are not happy with the results below please do another search

Archive for category: Product Releases

71

Syrus Firmware 2.1.20

/in

Syrus 2 FW 2.1.20 has been officially released! Corrections [list icon=”carat-1-e”] [item]Fixed, some ECU wrong values were reported due to incorrect data being analyzed.[/item] [item]Fixed, XAEM command returning wrong state when there’s no communication after an upgrade.[/item] [item]Fixed, valid gps events showed GPS source and age 90.[/item] [item]Fixed, mechanism that avoids the audio speaker rings...

This content is for registered Members only. You can register for free!
Login to view this content, or Register here
72

ECU Monitor Firmware 2.1

/in

ECU Monitor FW 2.1 Release Notes! Important! Before upgrading to this ECU FW version please read the  >>Upgrading Procedure! Corrections [list icon=”carat-1-e”] [item]Fixed, possible jumps and negative values ​​in the parameters read from the vehicle. This applies to all supported protocols.[/item] [item]Fixed, values stayed the same on some parameters.[/item] [/list] Improvements [list icon=”carat-1-e”] [item]Improved, analog...

This content is for registered Members only. You can register for free!
Login to view this content, or Register here
73

Syrus Firmware 2.1.05

/in

Syrus 2 FW 2.1.5 has been officially released! Corrections [list icon=”carat-1-e”] [item]Fixed, Garmin mode activation command did not return error if another serial mode was active.[/item] [item]Fixed, several photos were transmitted if a photo event included actions by event. (Only for serial camera mode 2).[/item] [item]Fixed, if checksum errors were detected the nmea sentences queue...

This content is for registered Members only. You can register for free!
Login to view this content, or Register here
74

Syrus Firmware 2.0.60

/in

Syrus 2 FW 2.0.60 has been officially released! Corrections [list icon=”carat-1-e”] [item]Fixed, Wrong source and age were reported when the Modem RTC was restarted by no voltage conditions. Now GPS source and age are changed to 90.[/item] [item]Fixed, When the application starts, wrong values could be assigned to ecu variables if group 2 was read...

This content is for registered Members only. You can register for free!
Login to view this content, or Register here